Depth of cut - layer thickness removed in one pass of workpiece under cutter - Manufacturing Processes - 2

Q.  The thickness of layer material removed in one pass of workpiece under the cutter is called as
- Published on 04 Aug 15

a. single pass cut
b. depth of cut
c. width of cut
d. face cut

ANSWER: depth of cut

Related Content

 

    Discussion

  • Pankaj   -Posted on 05 Nov 15
    - In milling process, the thickness of layer material removed in one pass of workpiece under the cutter is called as depth of cut.

    - For roughing cuts, common depth of cut is around 3 mm to 8 mm.

    - For finishing cuts, common depth of cut is less than 1.5 mm.

    - Material removal rate can be calculated with the known value of depth of cut.

    - The volume of metal removed in unit time is known as material removal rate.

    - Material removal rate = (Length of cut) / (Feed rate)

➨ Post your comment / Share knowledge


Enter the code shown above:

(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)
▲