Ping, Traceroute, Netstat, Ipconfig

Q.  Match the following  List 1 to List 2

1. Ping ------------ i) discover the routes
2.Traceroute ----- ii) method for troubleshooting the accessibility of devices
3. Netstat --------- iii) control the network connections on Windows NT/XP
4. Ipconfig -------- iv) finding problems in the network
- Published on 19 Oct 15

a. 1-iii, 2-i, 3-iv, 4-ii
b. 1-ii, 2-i, 3-iv, 4-iii
c. 1-i, 2-iii, 3-ii, 4-iv
d. 1-iv, 2-ii, 3-iii, 4-ii

ANSWER: 1-ii, 2-i, 3-iv, 4-iii

Related Content

 

    Discussion

  • wakjira   -Posted on 06 Oct 17
    learning system administration and network management
  • Prajakta Pandit   -Posted on 26 Oct 15

    - Following are the networking commands,

      1. Ping
      2. Traceroute
      3. Netstat
      4. Ipconfig

    - Ping command : It is very common method for troubleshooting the accessibility of devices. It uses a series of ICMP echo messages to determine.

    - Traceroute command : It is used to discover the routes that packets actually take while traveling to their destination.

    - Netstat command : Netstat (network statistics) is a command-line tool that displays network connections from both side that is incoming and outgoing. It is used for finding problems in the network and to determine the amount of traffic on the network as per performance measurement.

    - Ipconfig command : It is used to control the network connections on windows NT/XP machines. It allows you to get the IP address information of a window computer.

➨ Post your comment / Share knowledge


Enter the code shown above:

(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)
▲