Sampling Rate Converters - Designing Steps

Q.  Consider the assertions (steps) given below. Which among the following is a correct sequence of designing steps for the sampling rate converters?

A. Computation of decimation/interpolation factor for each stage.
B. Clarification of anti-aliasing / anti-imaging filter requirements.
C. Designing of filter at each stage.
D. Calculation of optimum stages of decimation/ interpolation yielding maximum efficient implementation.

- Published on 27 Nov 15

a. A, B, C, D
b. C, A, D, B
c. D, A, B, C
d. B, D, A, C

ANSWER: B, D, A, C

Post your comment / Share knowledge


Enter the code shown above:

(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)