switchport mode trunk command set trunk port on 2960 Switch - Networking

Q.  Which command gets set as a trunk port on a 2960 Switch?
- Published on 26 Aug 15

a. switchport mode trunk
b. trunk on
c. trunk all
d. switchport trunk on

ANSWER: switchport mode trunk

Related Content

 

    Discussion

  • Prajakta Pandit   -Posted on 23 Oct 15

    - To set a trunk port on a 2960 switch the switchport mode trunk command is used.

    - It allows all VLAN information to pass down the link.

    - What will happen if we use the switchport mode trunk command?

    - Using this command, the interface changes to permanent Trunking mode.

    - The port enters into a Dynamic Trunking Protocol (DTP) negotiation to convert the link into a trunk link even if the interface connecting to it does not agree to the change.

    - The switchport mode trunk command is the only method implemented in trunk configuration.

➨ Post your comment / Share knowledge


Enter the code shown above:

(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)
▲